Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









Search Auto Parts

2003 Toyota Echo


  Email This Post



computerinfoseeker23
User

Jul 31, 2014, 4:44 PM

Post #1 of 5 (1722 views)
2003 Toyota Echo Sign In

I have 123K miles on my echo and I have never had my rear brakes serviced. I want to do this for preventive maintenance purposes. I do my front disk brakes myself but have never done rear drum brakes nor do I want to or want to learn how. Here is my question. If I put my car in a local repair shop, how much can I expect to pay versus buying the parts (brake shoes) and brake cleaning fluid and allowing a mobile service tech come to my home and do the repair?

What should I expect to pay, parts and labor, for a repair shop to do this job. I just want some ballpark estimates please.

I have used mobile auto mechanics before and have been very pleased with the work. Thanks in advance for any replies.

**********Signature************
Cars = 2005 Nissan Altima (4 cylinder)
2003 Toyota Echo (4 cylinder)
1998 Honda Accord (6 cylinder)
**********Line****************


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Jul 31, 2014, 5:11 PM

Post #2 of 5 (1714 views)
Re: 2003 Toyota Echo Sign In

Preventative maintenance on brakes?

If you don't have a problem, leave them alone until they need to be replaced..



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



computerinfoseeker23
User

Jul 31, 2014, 5:18 PM

Post #3 of 5 (1711 views)
Re: 2003 Toyota Echo Sign In


In Reply To
Preventative maintenance on brakes?

If you don't have a problem, leave them alone until they need to be replaced..

Thanks Hammer. I have never serviced the rear drum shoes. How would I know or not if these shoes need to be serviced? I know how to inspect my front pads. Don't you think it is time for a rear drum brake job with 123K miles? I have done the front disk brakes about 3 or 4 times I think.

**********Signature************
Cars = 2005 Nissan Altima (4 cylinder)
2003 Toyota Echo (4 cylinder)
1998 Honda Accord (6 cylinder)
**********Line****************


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Jul 31, 2014, 6:36 PM

Post #4 of 5 (1710 views)
Re: 2003 Toyota Echo Sign In

You can simply pull a bake drum off and see how much brake is left.

If that's not something you know how to do, most shops will give free brake checks.



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



(This post was edited by Hammer Time on Jul 31, 2014, 6:37 PM)


Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Aug 1, 2014, 6:10 AM

Post #5 of 5 (1695 views)
Re: 2003 Toyota Echo Sign In

If you know these haven't been even looked at since new I would. Unless somehow remarkably corrosion free just getting drums off to check could break things and you should be ready for a whole brake job.


Shows two screws (probably Phillips headed) hold drum on and near certainly need and impact driver to remove those then fight with center hole stuck to hub and clearing an unworn ring over existing shoes.


Drum brake shoes can last a lot of miles and time but do build up dust and that should (IMO) be periodic to dump that out as it can't get out on it's own most I know of.


Highly likely to have troubles with the screws first, hub to drum and the unworn ring trapping shoes if they can't be retracted and might not so things will break. Don't re-use springs and hardware at the age and miles nor a drum that took a beating to get removed.


If you count on this car I'd just plain expect a whole rear brake job including all parts and hardware. You might be pleasantly surprised that these parts are not all the costly as things go to just do them or have done.


Again, IMO you need to know if you know nothing has been looked at in that time and miles,


T


(edit to show pic and a problem spot)
Drum should be like this......

The two tiny holes are for those screws. They are highly unlikely to just turn out with regular screwdriver or break as said. Drum is meant to be very snug to hub is next. You can't know without trying. If trouble with any and you don't have lots of common tools for dealing with them (easy hardware brake as things go) you are better off having this done vs buy all needed to get out of it once...........



(This post was edited by Tom Greenleaf on Aug 1, 2014, 6:22 AM)






  Email This Post
 
 


Feed Button




Search for (options) Privacy Sitemap