|
|
STEREOS GONE COMPLETLY DEAD!
|
|
|
| |
|
Guest
Anonymous Poster
Jul 19, 2007, 8:08 PM
Post #1 of 3
(4058 views)
|
STEREOS GONE COMPLETLY DEAD!
|
Sign In
|
|
Hi, i had my amp and sub put in yesterday and took the stereo out to make sure all the wires for the amp were in and they were but the stereo wouldnt go bak in! left it 4awhile and it worked fine, jus tried pushin it bak in and it went in but now it wont play at all. no lights coming on.. nothing, its completly dead. iv checked the wires again and checked with a moti meter and theres defiantley power going to it so dont know whats wrong with the actual head unit itself? its a sony one, any help plzz
|
|
| |
|
Guest
Anonymous Poster
Jan 31, 2008, 6:58 PM
Post #2 of 3
(3861 views)
|
Re: STEREOS GONE COMPLETLY DEAD!
|
Sign In
|
|
check and see if you have a door and headlight chime when you leave the keys in and door open or headlights on. If you don't, check the chime fuse in your fuse panel. Also check and see if there is a fuse on the stereo itself and make sure you check your actual radio fuse. I had this problem and I was clueless and then found out that I needed to replace the fuse for the door chime. Hope that this helps you and if it does, consider this paying it forward!!!! hope it helps!!!
|
|
| |
|
DrElectrics
Enthusiast
Jan 31, 2008, 9:33 PM
Post #3 of 3
(3859 views)
|
Re: STEREOS GONE COMPLETLY DEAD!
|
Sign In
|
|
You may have pinched the power wire in the cradle when stuffing it back in. It will detect power as the whole cradle will be active. If you have it earthed properly you should be ok. The fuse would of blown. If the earth was good enough...(worst case scenario) You could have blown your head unit. Check power wire to make sure its not stripped, bent, or broken, then check earth wire and finally negative. Let me know what happens. PS - You say you have a multi meter, do a wire continuity check on your power wire. Just to make sure there are no internal breaks.
|
|
| |
|