|
|
stretchy
New User
Jul 24, 2012, 10:38 AM
Post #1 of 4
(3244 views)
|
2007 mazda 6 windows
|
|
|
my '07 mazda 6 had its battery fried the other day because of the heat outside. I replaced the battery and its all working now except the power windows, the passenger window control on the driver side no longer works and the automatic option on the passenger window no longer works either (in other words i can open the window only by using the passenger control and the auto option does not work)
of course everything worked fine before the battery died.
when the battery died I tried starting the car a few times before i realised it was no use and the fuse box started to click (Short circuit im assuming) when i tried to start it with the dead battery
my only assumption is that the fried battery + my attempt at starting the car cooked some wires and now i must get them replaced?
please help :)
Devon
|
|
| |
|
|
stretchy
New User
Jul 24, 2012, 11:44 AM
Post #2 of 4
(3223 views)
|
|
Re: 2007 mazda 6 windows
|
|
|
im now starting to think that i need to reset my windows, any opinions?
|
|
| |
|
|
stretchy
New User
Jul 24, 2012, 12:00 PM
Post #3 of 4
(3218 views)
|
|
Re: 2007 mazda 6 windows
|
|
|
success!!
This is the procedure that worked for me for anyone with similar problems
This is a quote from the workshop manual
Note
? A driver side window will not fully close automatically under following the conditions:
? The battery has been disconnected during vehicle maintenance or for other reasons.
? The power window main switch connector, or driver-side power window motor connector has been
disconnected.
? Carry out the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window,
and keep holding the switch up at the position for about 2 seconds to complete initial setting.
TWO-STEP DOWN FUNCTION OPERATIVE/NON-OPERATIVE SWITCHING PROCEDURE
Note
? By following the procedure below, the two-step down function is switched to non-operative when it is
operative, and to operative when it is non-operative.
Turn the Ignition on
Within 5 sec
perform the auto open two times
perform the auto close two times
turn the ignition off and within 40 seconds and repeat the above sequence.
Repeat for all the windows.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jul 24, 2012, 12:40 PM
Post #4 of 4
(3212 views)
|
|
Re: 2007 mazda 6 windows
|
|
|
Just getting ready to post that. Glad to see you figured it out. Thanks for the follow up
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
TELC -Zertifikat A2, c* Sweden WhatsApp +52 6643030891 Get TELC-TESTDAF-DSH-Zertifikat B2 without exam in * Finland
2001 Saturn Interior lights flashing
2018 Ford Fusion Titanium Hybrid swaying issue
2008 Nissan altima 2.5L will not crank.
