|
|
1999 ford taurus battery drainage
|
|
|
| |
|
emily
Novice
Jun 7, 2009, 8:19 AM
Post #1 of 8
(4172 views)
|
1999 ford taurus battery drainage
|
Sign In
|
|
we have a 1999 ford taurus 3.0 it drains the battery in 15 minutes while the car is running we tested the voltage with a volt meter dvm to measure the voltage drop across the live connection while it is under the load we cleaned all the connections and it is still killing the battery we had 12.5 volts in the battery last night but the starter was only reading 7 volts then today we tried it & it is still killing the battery could you please give us a idea of what to do thank you so much
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 7, 2009, 8:47 AM
Post #2 of 8
(4167 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
The first thing you need to do is have the battery itself tested to determine if it's even capable of holding a charge. Then once you have a known good and fully charged battery, you then need to use a digital voltmeter to test the voltage across the battery with the engine running at idle with no accessories on to see if it's charging properly. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Jun 7, 2009, 8:48 AM)
|
|
| |
|
emily
Novice
Jun 7, 2009, 9:02 AM
Post #3 of 8
(4163 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
WE ALREADY TESTED THAT & EVERYTHING IS TESTING GOOD DO YOU HAVE ANY OTHER SUGGESTINS THIS IS OUR ONLY CAR & OUR SON HAS TO HAVE SURGERY DONE ON TUESDAY WE GREATLY APPRECIATE YOUR TIME & ADVICE THANKS AGAIN
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 7, 2009, 9:04 AM
Post #4 of 8
(4159 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
What is the charging voltage? ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
emily
Novice
Jun 7, 2009, 9:23 AM
Post #5 of 8
(4154 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
the charing voltage last night was 12.5 in the battery but, the starter was only 7 volts thanks again
|
|
| |
|
Loren Champlain Sr
Veteran
/ Moderator
Jun 7, 2009, 2:31 PM
Post #6 of 8
(4138 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
Pardon my jumping in here; \ Emily; As Hammer suggested, you need to check the charging voltage. 12.5V is not enough. It should be charging a minimum of 13.6V at idle. If your voltage is droppping from 12.5 to 7.0V during cranking, sounds like a bad battery or a really bad starter. But.....you need to address the battery and charging voltage first. Loren SW Washington
|
|
| |
|
emily
Novice
Jun 7, 2009, 3:22 PM
Post #7 of 8
(4135 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
that's ok we will take any advise we can get it's been 5 day's now & i'm sure you can imagine the state of mind we're in we are tring to find out how to find a fusible link diagram because there is a box of fuses right beside the battery that doesn't show any numbers or anything but, there is one in front of the battery that show's numbers & the manual will show what they are for but, not for the one beside the battery we were thinking maybe the starter too but he already had it off & it was good too thank's again we will take any advise
|
|
| |
|
autojoe
User
Jun 8, 2009, 1:41 AM
Post #8 of 8
(4125 views)
|
Re: 1999 ford taurus battery drainage
|
Sign In
|
|
like hammer and loren stated have to provide the info they requested before moving on.Have to eliminate charging system.take multimeter positive to battery positive and negative meter to battery negative terminal and start vehicle and see what the charging voltage is.If won;t start charge battery and test.if still low leave meter negative hooked to battery negative and hook positive meter to the output stud at alternator and see if it is higher.
|
|
| |
|