Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









fault codes


Search for (search options)
 



barnel
New User

Feb 17, 2012, 6:20 PM

Post #1 of 4 (3498 views)
fault codes Sign In

I have a 2009 Dodge Challenger with 2 fault codes V0126 and P0730 can any explain they are, and if its some part where its located any help would be great


Discretesignals
Ultimate Carjunky / Moderator
Discretesignals profile image

Feb 17, 2012, 7:00 PM

Post #2 of 4 (3469 views)
Re: fault codes Sign In

which engine? Haven't seen a trouble code starting with V. Usually the codes start with P,B,C or U. You sure that is right?





Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.

(This post was edited by Discretesignals on Feb 17, 2012, 7:03 PM)


barnel
New User

Feb 17, 2012, 8:20 PM

Post #3 of 4 (3441 views)
Re: fault codes Sign In

the motor is 5.7 the v code says its lost communicationwith steering angle sensor what ever that is


Discretesignals
Ultimate Carjunky / Moderator
Discretesignals profile image

Feb 17, 2012, 8:46 PM

Post #4 of 4 (3433 views)
Re: fault codes Sign In

P0730 means the TCM (transmission control module) saw an incorrect gear ratio. The TCM monitors the gear ratio of which ever gear it is commanding by watching the speed sensors in the transmission. This problem is definitely going to require a high end scan tool to look at the freeze frame to see what gear the transmission was in when the code set. You'll also have to monitor the speed signals. If everything is ok electrically, there could be something going on inside the transmission. Make sure the fluid level is good.

Still don't understand your V code. I think you are confusing V with the letter U. U0126 is the steering angle sensor module lost communications ABS controller. The sensor is used by that system so it knows the position of the steering wheel for yaw control when you over steer.

You'll need that same enhanced scan tool to see if the angle sensor module is actually active on the data bus. If the module isn't active, you have to figure out why. Is it missing power or ground, has data bus problems, or has the module failed internally? No way to know unless testing is done.

I have a feeling that you might be over your head if you plan on attempting to figure this out yourself.





Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.

(This post was edited by Discretesignals on Feb 17, 2012, 8:57 PM)






 
 
 






Search for (options) Privacy Sitemap