1990 olds cutlas no power - Engine Troubleshooting


	Auto Repair Home	SEARCH POSTS	WHO'S ONLINE	LOG IN

Automotive Repair

Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:
  Login
  Sign up here!

Latest Forum Post

Lukewarm Heat............

New antifreeze reverse flush heater core...

multiple warning lights

2013 GMC Terrain 130,000 miles 4 cylinde...

2014 Nissan Sentra Shaking

Car recently started shaking when accele...

Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086

N/A

1989 toyota pickup 3.0 crank no start

I have a 1989 toyota pickup 3.0 crank no...

Strut spring orientation and strut mount tension nut

2017 Nissan rogue awd 2.5 L Put in Monro...

Transmission stuck in part, I have tried everything

So I'm working on my elderly fathers 201...

2017 dodge journey LED headlights on/off randomly

Year of vehicle 2017 Make of vehicle dod...

Kia Soul starter replacement issues!

Okay so my car is a 2010 Kia soul 2.0 en...

Please Help - Knock sound & engine fail

Hi all, Hoping to get some insight and ...

1990 olds cutlas no power

Sign up here!

Search for (search options)

Auto Repair Home>> Automotive Repair>> Engine Troubleshooting

dsteelman
New User

Mar 23, 2008, 12:02 PM

Post #1 of 4 (1479 views)

1990 olds cutlas no power	Sign In

i have 1990m olds cutlas supreme 3.1 v6. i have replaced the map sensor the o2 sensor and the plugs and wires and i have checked the fuel pressure and it says its fine but when i step on the gas it just loses all power if you could please help me . i took out the 02 sensor and started the car to see if my cat was clogged but it still did the same thing

(This post was edited by dsteelman on Mar 23, 2008, 1:01 PM)

DanD
Veteran / Moderator
DanD profile image

Mar 23, 2008, 12:54 PM

Post #2 of 4 (1471 views)

Re: 1990 olds cutlas no power	Sign In

Possibly a restricted exhaust system as in a plugged catalytic converter?

Dan.

Canadian "EH"

dsteelman
New User

Mar 23, 2008, 12:58 PM

Post #3 of 4 (1468 views)

Re: 1990 olds cutlas no power	Sign In

i took out the 02 sensor and started the car and it still had no power

DanD
Veteran / Moderator
DanD profile image

Mar 23, 2008, 2:37 PM

Post #4 of 4 (1455 views)

Re: 1990 olds cutlas no power	Sign In

I understand your thinking that removing the O2 should relieve the back pressure of a restricted system but it may not be enough? Dropping the system off of the rear manifold would defiantly confirm whether there was a restriction. Plus that would also allow the 02 to remain connected.
Have you performed an engine compression test; ensuring that general engine condition is ok?
Check engine manifold vacuum; it should be around 18 to 20 inches of mercury and fairly steady at idle. A significant drop in vacuum and a fast vacuum gauge reading recovery; when you snap the throttle open and closed.
Have you checked that there is a strong vacuum supply to the map sensor? The hard plastic vacuum lines that feed vacuum to the sensor can crack & leak.
If all of the above is ok then it might be time to have a scanner connected to the PCM? Not just to read codes but to monitor sensor data and how the PCM reacts to the data.

Dan.

Canadian "EH"

Search for (options) Privacy Sitemap