|
|
|
2014 Cadillac SRX Won’t Crank After Collision
|
|
|
| |
|
|
Ekyauto
Novice
May 16, 2020, 5:45 AM
Post #1 of 18
(4372 views)
|
|
2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Hey All! Need some help or suggestions. I’m in the process of rebuilding a 2014 SRX that was hit in the front. Opening the door the display is on, however when I press the start button it just shuts off and flashes the check engine light. It does NOT crank or make any noises, so it doesn’t appear that it even attempting to start. Initially I thought the easy stuff, fuses, relays, and battery. I checked all the fuses and relays they seemed fine. I swapped the battery with a new one to provide consistent voltage, not no avail... The engine appears to be in perfect condition and doesn’t appear to have any external damage, the airbags were NOT deployed in the car, so I’m narrowed down to a possible ECU issue or possibly an odd factor that I’m not considering.
is there any rebuilders out there with experience in a similar situation?
thanks in advance.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 16, 2020, 6:57 AM
Post #2 of 18
(4366 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Have you done a complete scan here including body and restraint modules?
Are you getting any dash messages when you attempt to start it?
Have you monitored a scan tool to be sure the PCM is seeing it in Park/Neutral?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Sidom
Veteran
/ Moderator
May 16, 2020, 8:49 AM
Post #3 of 18
(4357 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Get a wire brush and clean all the connections at the battery. Take all the grounds apart and clean those as well..... Even if they look good
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 8:29 AM
Post #4 of 18
(4312 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
So we scanned the modules and were able to communicate with just about everything besides the ECM and TCM. We’ve moved it in and out of gear, so I’m not thinking it’s not fully in Park.
One odd thing is the lift gate won’t go up. The computer indicates the car is going to fast to open. So obviously something isn’t sensing the car is in park and not moving
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 8:30 AM
Post #5 of 18
(4310 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Cleaned all the connections and grounds as well.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 17, 2020, 8:34 AM
Post #6 of 18
(4308 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Scanning for codes is not how you determine if the Transmission position sensor is working properly.
You need to look at data in the scan tool. There should be a PID that tells you what position the gearshift selector is in.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 8:36 AM
Post #7 of 18
(4303 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
The tool is able show show the vehicle is in park from the BCM, but cannot connect the TCM.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 17, 2020, 8:42 AM
Post #8 of 18
(4297 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
That could be a problem. I'm assuming there is a communication issue with the data bus and not a problem with the scan tool?
You really need to know why there is no communication with the TCM. Were there any "U" codes in any of the modules?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 8:56 AM
Post #9 of 18
(4293 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Yes, there were 3 “U” codes
U0100-00-Loss Comm with ECM
U010-00- Loss Comm with TCM
U0402-71- Invalid Data from TCM
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 17, 2020, 9:01 AM
Post #10 of 18
(4287 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
OK, those were important facts to leave out of your question.
Obviously it should have a lot of verification testing but it sounds like you may have a bad TCM.
Test all the powers and grounds into it first. Then make sure you have to harness damage.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 9:04 AM
Post #11 of 18
(4283 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Would you happen to have or know where I can locate a pinout wiring schematic?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 17, 2020, 9:21 AM
Post #12 of 18
(4268 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
The module is internal to the trans
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Ekyauto
Novice
May 17, 2020, 9:40 AM
Post #13 of 18
(4262 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Great, thank you.
So we checked the voltage to the TCM plug, I have 11.6 volts to the red/green wire and vio/black wire with reference to both black/white negatives. The only other wires are the data wires.
That would indicate that the TCM is bad with no communication to the BCM but that still doesn’t answer why I have no comm to the ECM.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 17, 2020, 9:43 AM
Post #14 of 18
(4257 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
You still could have a data line or ground problem elsewhere in the car.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on May 17, 2020, 9:45 AM)
|
|
| |
|
|
Ekyauto
Novice
May 27, 2020, 6:28 PM
Post #15 of 18
(4052 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
So it appears to be to be an issue with the TCU, and since the module is within the transmission casing I’m guessing it would be best to replace the entire transmission. Do you know if the transmission would need to be programmed to the vehicle or would it be plug and play?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 27, 2020, 6:46 PM
Post #16 of 18
(4048 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
The TCM is incorporated into the valve body and solenoid pack and is serviceable in the car.
You can buy an OEM part for around $350 but it will need programming.
https://www.rockauto.com/...trol+unit+(tcu),8480
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on May 27, 2020, 6:47 PM)
|
|
| |
|
|
Ekyauto
Novice
May 28, 2020, 4:12 AM
Post #17 of 18
(4021 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
We had looked into just replacing the TCM, but after inquiring about the cost with our local GM dealer they quoted us $1000 To program it. I’m just a little worried that he impact jarred something else and maybe just a complete swap would be better suited since I can get a transmission for about 1200.
Do you know if a complete transmission from another SRX would need to be programmed? I’m hoping it would be plug and play
(This post was edited by Ekyauto on May 28, 2020, 4:14 AM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
May 28, 2020, 12:01 PM
Post #18 of 18
(3997 views)
|
|
Re: 2014 Cadillac SRX Won’t Crank After Collision
|
Sign In
|
|
Yes, I would expect it will need programming to your VIN#
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
