|
|
|
95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 3:04 PM
Post #1 of 15
(1569 views)
|
95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Had to replace distributor pick up went bad. Had a bad explosion when installing new distributor. I have replaced the I a c (a couple of them) m a p and the throttle position sensor and computer and changed the prom to the new computer. No codes recording at this time
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 3:25 PM
Post #2 of 15
(1564 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
So, what is the issue now? What is your question?
You DO realize you need a professional scan tool to install that distributor.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 3:35 PM
Post #3 of 15
(1558 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Won't idle at start up when warmed idle is up and down and stalls sometimes when coming to a stop and poor acceleration. Also I have replaced plugs and wires. I set the timing with the wire unplugged to the computer as suggested in the repair manual.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 3:40 PM
Post #4 of 15
(1554 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Yes, you're right. I thought it was a later model.
Double check your firing order and wire locations.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 3:50 PM
Post #5 of 15
(1550 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
I have checked and rechecked all the wires. I have checked all the sensor wires back to the computer with a tester
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 3:55 PM
Post #6 of 15
(1548 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Also have a popping in the motor when trying to make hard acceleration this happens when transmission shifts into next gear
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 4:01 PM
Post #7 of 15
(1542 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Have you checked for codes?
Double check your timing again.
Check your fuel pressure, noting what it does when shut off.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 4:12 PM
Post #8 of 15
(1536 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
I have rechecked the timing its set at 4 degrees btdc. I don't have fuel pressure port . I have a snap on scanner it doesn't show fuel pressure it has fuel trim it is between 154 @start up and goes down to 137 does that help Idk what fuel trim number should be
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 4:17 PM
Post #9 of 15
(1533 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Are you reading block learn or integrator? Long term or short term?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Jun 25, 2017, 4:18 PM)
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 4:27 PM
Post #10 of 15
(1527 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
Not sure what that is
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 4:31 PM
Post #11 of 15
(1521 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
There is a short term reading and a long term reading. In the early years they called it block learn and Integrator. More recently it is called long term and short term fuel trim. I need to know if that reading was from the short term or long term.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 5:02 PM
Post #12 of 15
(1517 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
The scanner is an older snap on how can I find out which one it is
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 5:06 PM
Post #13 of 15
(1515 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
There is a label next to the number. How did you know it was fuel trim? What exactly did it say. The acronym should start with either LT or ST or BLN or INT.
If you are using an MT2500, it should tell you that.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
95 Chevy k3500
Novice
Jun 25, 2017, 5:22 PM
Post #14 of 15
(1509 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
It's a 2597-2995 snap on it is long term
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2017, 5:30 PM
Post #15 of 15
(1503 views)
|
|
Re: 95 Chevy k3500 Silverado 7.4 won't idle poor acceleration
|
|
|
OK, that helps.
Your scanner is a 2500 with graphing nicknamed the brick.
The center or ideal point is 128. Anything higher than that and the computer is adding fuel to overcome a lean mixture. Anything less than 128 and the computer is taking fuel away because it's too rich.
Your's is reading high which means you have a lean mixture for some reason. First use the scanner and verify temp reading for the ECT and IAT. They should match each other if the engine hasn't been running.
If nothing found there, look for other possible reasons. Look at both fuel injectors with the engine running and make sure you are getting a good, steady pattern. Check for any possible vacuum leaks.
You still may have to test fuel pressure. They make an adapter that goes in place of the fuel filter with a service port.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Jun 25, 2017, 5:35 PM)
|
|
| |
|
| | |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Brake & Turn Signal Out - One side only
Crown vic no start with key
