|
|
|
96 grand am starts then immidiate cutoff
|
|
|
| |
|
|
steve1
User
Jul 28, 2010, 4:58 PM
Post #1 of 8
(1935 views)
|
|
96 grand am starts then immidiate cutoff
|
Sign In
|
|
car starts then quits. have poured fuel into aircleaner but got same result.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 28, 2010, 5:08 PM
Post #2 of 8
(1922 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
Is the security light flashing when this happens?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jul 28, 2010, 5:28 PM
Post #3 of 8
(1909 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
steve; Don't pour gas into the air cleaner. Very dangerous. After answering HT's question, we can go from there.
Loren
SW Washington
|
|
| |
|
|
steve1
User
Jul 28, 2010, 5:55 PM
Post #4 of 8
(1900 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
no. but car was stolen before we got it. ignition switch was replaced and car has been driven daily. security light does not come on at all. even at run pos.ition on keyswitch
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 28, 2010, 6:12 PM
Post #5 of 8
(1879 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
It's acting like the security system is kicking in but the light should be flashing if that were the case. You probably want to verify fuel pressure first and make sure that's in spec. The spec is 41 to 47 PSI. If fuel pressure is good you can try the Passlock relearn below but since the light is not flashing, I wouldn't get my hopes up on that.
PASSLOCK REPROGRAMMING AUTO LEARN
IMPORTANT: Due to component variability, the vehicle theft deterrent (VTD) system must have the learn procedure performed regardless, if the vehicle starts on the first ignition cycle after a VTD repair.
You must perform a theft relearn procedure if any of the following components have been replaced: - Passlock Sensor
- Instrument Panel Cluster (IPC)
- Powertrain control module (PCM) The above modules, with the exception for the Passlock Sensor must also be programmed with each module's own vehicle configuration.
AUTO LEARN
Time required, approximately 10 minutes: - Insure that the battery is fully charged.
- Use the scan tool in order to clear the DTCs.
- Turn the ignition switch from the OFF position to the CRANK position attempting to start the vehicle. The vehicle will start and then stall.
- Leave the ignition switch in the ON position while observing the security indicator.
- When the security indicator turns off, which can take up to 10 minutes, turn the ignition switch off. Wait 10 seconds.
- The BCM and the PCM will learn the new code on the next start attempt.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
steve1
User
Jul 28, 2010, 7:07 PM
Post #6 of 8
(1872 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
trying the passlock reset got the car to run but it is sickly. tomorrow i can check the codes and get further. thank you!
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 28, 2010, 7:09 PM
Post #7 of 8
(1869 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
You must have a problem with that security light too. It should have been flashing.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
steve1
User
Jul 28, 2010, 7:22 PM
Post #8 of 8
(1863 views)
|
|
Re: 96 grand am starts then immidiate cutoff
|
Sign In
|
|
you are correct about that. it should at least light up as key is turned to run before starting. i belive in my heart that it has been unplugged or removed due to prior theft.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
