|
|
mtech
User
Oct 30, 2008, 8:31 PM
Post #1 of 2
(2836 views)
|
|
Engine misfire Cyl. 2
|
Sign In
|
|
I have a 2004 mini cooper with a misfire in cyl. #2 only when car is hot. i have swapped spark plugs from cyl. 2-3 and injectors from cyl. 2-1. (misfire did not follow plugs or injectors) installed a new coil pack, swapped out plug wires and cranking compression is good. performed a leakdown test numbers were high but all the same. I do have spark fuel and compression. I am thinking a valve problem or electrical problem with the engine control unit. don't know where to go any advice.
(This post was edited by mtech on Oct 30, 2008, 8:38 PM)
|
|
| |
|
|
DanD
Veteran
/ Moderator
Nov 1, 2008, 8:44 AM
Post #2 of 2
(2805 views)
|
|
Re: Engine misfire Cyl. 2
|
Sign In
|
|
You could try a running compression test; it’s not a very conclusive test but if you compare #2 to a known good cylinder and #2 is considerably lower. Then yes you may have a valve guide problem, allowing a valve to bounce off of its seat; lowering its compression?
My next thought is possibly an intake manifold vacuum leak; either a gasket too cylinder head leak or a vacuum leak of some sort only affecting #2?
The computer on this vehicle does manage each injectors firing individually; so yes maybe for some reason the computer is dropping this cylinder.
If you can get your hands on a lap scope; I would have it connected to that injector’s circuit. Checking the injector’s firing pattern during the misfire; again comparing it to a known good cylinder’s injector’s pattern.
I hate misfires when you seem to have everything you should and the thing just doesn’t want to give up its secret.
Dan.
Canadian "EH"
|
|
| |
|
| | |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 