KNOW ONE CAN FIGURE - Engine Troubleshooting


	Auto Repair Home	SEARCH POSTS	WHO'S ONLINE	LOG IN

Automotive Repair

Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:
  Login
  Sign up here!

Latest Forum Post

Lukewarm Heat............

New antifreeze reverse flush heater core...

multiple warning lights

2013 GMC Terrain 130,000 miles 4 cylinde...

2014 Nissan Sentra Shaking

Car recently started shaking when accele...

Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086

N/A

1989 toyota pickup 3.0 crank no start

I have a 1989 toyota pickup 3.0 crank no...

Strut spring orientation and strut mount tension nut

2017 Nissan rogue awd 2.5 L Put in Monro...

Transmission stuck in part, I have tried everything

So I'm working on my elderly fathers 201...

2017 dodge journey LED headlights on/off randomly

Year of vehicle 2017 Make of vehicle dod...

Kia Soul starter replacement issues!

Okay so my car is a 2010 Kia soul 2.0 en...

Please Help - Knock sound & engine fail

Hi all, Hoping to get some insight and ...

KNOW ONE CAN FIGURE

Sign up here!

Search for (search options)

Auto Repair Home>> Automotive Repair>> Engine Troubleshooting

904jason
New User

Nov 10, 2008, 11:25 PM

Post #1 of 4 (1548 views)

KNOW ONE CAN FIGURE	Sign In

94 acura vigor with aleeky water pump.added water drove 22 miles ran great intill a little BLUE smoke ONLY
started comeing out of tail pipe then lost most power the just died.
temperture gage showed fine but engin was steaming and blowing water out if radiator
added water little by little tryed to crank it and it was fireing not enough to start and run
now it just turns over and over and nothing and the compression is fine on all cilinders
IS THERE SENSER THAT SHUTS THE MOTOR DOWN WHEN IT OVER HEATS

Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Nov 11, 2008, 5:56 PM

Post #2 of 4 (1533 views)

Re: KNOW ONE CAN FIGURE	Sign In

Hopefully, you haven't done any lasting damage. First, the coolant temp sensor must be in contact with coolant for it to register properly. So, if you've lost your coolant due to a water pump leak, there's a very good chance that's why the guage didn't register hot. It sounds like you've lost compression from it getting so hot that it washed the cylinder walls of oil. You can remove the spark plugs and pour in a little oil in each cylinder (about .5
ounce per cyl), crank the engine over a few times, then perform a compression test. If you don't have a compression guage, put the plugs back in and see if it cranks over "more normally". If you are lucky, the compression will return by allowing the rings on the pistons to reseal with the added oil. And, if you're real lucky, it may start and run. Of course, it will smoke blue smoke until the oil that you put in burns off. Now, if all is good in the world, you can replace the water pump AND the thermostat and hope for the best. I'd fill it with just water in case you have blown your head gasket due to overheating, so you don't waste anti-freeze. Good luck.
Loren
SW Washington

Big-T
User

Nov 11, 2008, 6:03 PM

Post #3 of 4 (1530 views)

Re: KNOW ONE CAN FIGURE	Sign In

Just a helping hand Land....He/She noted that compression is fine....

Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Nov 11, 2008, 6:07 PM

Post #4 of 4 (1528 views)

Re: KNOW ONE CAN FIGURE	Sign In

OOOPS...Just re-read. You're right. Thanks.
Loren
SW Washington

Search for (options) Privacy Sitemap