|
|
shaffer017
New User
Mar 9, 2009, 12:04 AM
Post #1 of 7
(1132 views)
|
help me please
|
Sign In
|
|
my car runs fine when its cold. when it gets up to operating temp it starts to flutter then die then it wont start for about 1 hour then will run fine till it gets hot again. i replaced the egr valve the coil packs and the icm,and fuel filter and i still have the same problem. i took in to a shop and hooked it up to a computer and flashed no codes and tested the fuel pressure from the fuel rail and tested good, but told me the EGR valve was electronicly unplugged. they plugged it in and seemed to run fine. so i left and two blockes down the road it flutters and dies while im driving. it doesnt matter if im driving or im parked it does the same thing
|
|
| |
|
|
Jeff Norfolk
Enthusiast
Mar 9, 2009, 6:35 AM
Post #2 of 7
(1130 views)
|
|
Re: help me please
|
Sign In
|
|
Year make and model?
Jeff
|
|
| |
|
|
shaffer017
New User
Mar 9, 2009, 2:24 PM
Post #3 of 7
(1125 views)
|
|
Re: help me please
|
Sign In
|
|
1989 oldsmobile cutlass 3.1L v6
|
|
| |
|
|
Double J
Veteran
/ Moderator
Mar 9, 2009, 4:29 PM
Post #4 of 7
(1119 views)
|
|
Re: help me please
|
Sign In
|
|
If they tested the fuel pressure and it tests ok
Test the Injectors.
They may being shutting down the Quad drivers in the ECM (computer)
If this is the case,i would replace all 6 injectors and the ECM.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Mar 9, 2009, 4:45 PM
Post #5 of 7
(1117 views)
|
|
Re: help me please
|
Sign In
|
|
Another thing to check; Check for spark when it dies. Crank sensors and control modules were common failures on these engines. Either can be heat related, and neither will always set a trouble code.
Loren
SW Washington
|
|
| |
|
|
shaffer017
New User
Mar 9, 2009, 8:32 PM
Post #6 of 7
(1110 views)
|
|
Re: help me please
|
Sign In
|
|
i checked the spark when it died and there is no spark at all
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Mar 10, 2009, 3:28 PM
Post #7 of 7
(1105 views)
|
|
Re: help me please
|
Sign In
|
|
If you can get your hands on a scanner, look for cranking rpm. And, a noid light to check for injector pulse. I'd suspect the crank sensor, first, but still could be a control module. Hopefully, I'm wrong on the module. They are quite expensive.
Loren
SW Washington
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
