|
|
dtate
New User
Mar 11, 2012, 6:03 PM
Post #1 of 8
(1530 views)
|
I have a 1984 v6 (2.8) carb camaro. My son drove it home yesterday with no problems. Went out to go to town and car would not start, just crank over. i checked wires under carb, all good. I pulled distributor and cleaned, i pulled coil wire and cleaned both ends.I then replaced the coil. I pulled coil wire at distrib. and put spark plug in and cranked over. good spark. unhooked plug wire from spark plug in motor and pluged spark plug in and cranked, no spark. any help would be appreciated
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 11, 2012, 6:17 PM
Post #2 of 8
(1520 views)
|
The ignition module was a common failure on those.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
dtate
New User
Mar 11, 2012, 6:33 PM
Post #3 of 8
(1500 views)
|
can i change moduel or do i have to replace distributor all together? appreciate ur help
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 11, 2012, 6:35 PM
Post #4 of 8
(1497 views)
|
No, you can replace the module pretty easily.. ... a couple plugs and 2 screws
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Mar 11, 2012, 6:37 PM)
|
|
| |
|
|
dtate
New User
Mar 12, 2012, 3:24 PM
Post #5 of 8
(1437 views)
|
well just changed moduel and still no start. changed coil, moduel, and made sure distributor was turning. im out of ideas help lol
|
|
| |
|
|
dtate
New User
Mar 13, 2012, 6:25 PM
Post #7 of 8
(1407 views)
|
well got out and worked on car again. start from begining and found after i put igni. moduel on and put air cleaner back on i managed to unplug coil wire (my luck) plugged it in and car started. shut off and restarted several times, and seems to be workin fine. I appreciate all the help thanks again
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 13, 2012, 6:33 PM
Post #8 of 8
(1400 views)
|
So, it was a bad module after all?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
