Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









no start 1996 jeep cherokee 4.0l inline


Search for (search options)
 



mrp
New User

Nov 22, 2009, 6:13 PM

Post #1 of 3 (3341 views)
no start 1996 jeep cherokee 4.0l inline Sign In

1996 jeep cherokee 4.0l inline 6 cyl.
here is my problem. i swapped motors.everything on the new motor came from the original motor.when it cme to start it it would not start.i have spark, fuel and compression. when turning over it shows rpm on the scanner.there are no fault codes.the dist. was installed #1 at tdc compression stroke. and rotor at #1 the computer does the timing.the only thing i noticed was the new block had a adj. dist clamp on it and the dist is a fixed slot.


(This post was edited by carjunky on Nov 22, 2009, 9:54 PM)


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Nov 23, 2009, 5:59 AM

Post #2 of 3 (3334 views)
Re: no start 1996 jeep cherokee 4.0l inline Sign In

Have you checked to see if you have the distributor 180 out?



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Nov 23, 2009, 7:12 PM

Post #3 of 3 (3324 views)
Re: no start 1996 jeep cherokee 4.0l inline Sign In

mrp; Which flywheel (or flex-plate) did you use? You should have used the original one from your original engine. The crank sensor/reluctor must match.
Loren
SW Washington






 
 
 






Search for (options) Privacy Sitemap