|
|
|
replaced the starter still wont start
|
|
|
| |
|
|
darrenballas
New User
Apr 21, 2008, 6:32 PM
Post #1 of 6
(3092 views)
|
|
replaced the starter still wont start
|
Sign In
|
|
I HAVE A 95 GMC SIERRA 6.5 TURBO DIESEL.THE STARTER WENT.AFTER REPLACING THE STARTER,THE TRUCK STILL WONT START.IT TURNS OVER NOW, BUT NOT STARTING.I DISCONNECTED THE BATTERIES IN THE PROCESS.COULD I HAVE DONE SOMETHING WRONG.ALSO REPLACED THE FUEL PUMP LAST WEEK.UP UNTIL TODAY WHEN THE STARTER WENT IT WAS RUNNING.CANT SEEM TO FIGURE IT OUT.ANY ADVICE THANKS DARREN ..........IM GOING TO ANSWER MY OWN QUESTION A LITTLE STARTER FLUID DID THE TRICK
(This post was edited by darrenballas on Apr 21, 2008, 7:12 PM)
|
|
| |
|
|
dave284
Enthusiast
Apr 22, 2008, 12:16 PM
Post #2 of 6
(3074 views)
|
|
Re: replaced the starter still wont start
|
Sign In
|
|
Good.....I was going to say the fuel system had an air in it
|
|
| |
|
|
darrenballas
New User
Apr 26, 2008, 9:28 AM
Post #3 of 6
(3056 views)
|
|
Re: replaced the starter still wont start
|
Sign In
|
|
hey dave it seems as though my truck is not getting fuel now i replaced the fuel pump last week.it ran fine for a few days then cut out while i was driving.its started after spraying the fluid in,then died again.im ready to drive this truck into the lake nothing but problems since i bought it last year any ideas
|
|
| |
|
|
dave284
Enthusiast
Apr 26, 2008, 9:51 AM
Post #4 of 6
(3053 views)
|
|
Re: replaced the starter still wont start
|
Sign In
|
|
Can you hear the fuel pump prime itself ? Also have you changed the fuel filter?
|
|
| |
|
|
darrenballas
New User
Apr 26, 2008, 10:45 AM
Post #5 of 6
(3050 views)
|
|
Re: replaced the starter still wont start
|
Sign In
|
|
thanks dave for getting back to me so quickly yes i can here the fuel pump and acttually when it first happened i replaced the fuel filter thinking id start off small. i replaced the fuel pump a few days after the filter. would this make a difference. thanks darren
|
|
| |
|
|
dave284
Enthusiast
Apr 26, 2008, 11:42 AM
Post #6 of 6
(3047 views)
|
|
Re: replaced the starter still wont start
|
Sign In
|
|
It seems to me its a circut/sensor problem.....you need to retrieve any stored trouble codes in the computer....there are several things that would cause the (no start).....make sure there are no shorted out fuses, bad glow plugs,bad injector harness....guessing would become expensive...even the computer itself can be at fault....so if I were you....I would get a diagnostic scan done before replacing any other parts and go from there.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
