Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









stalling


Search for (search options)
 



Bill45
Novice

Nov 25, 2009, 3:58 PM

Post #1 of 13 (1876 views)
stalling Sign In

My 95 caravan 3.0 starts right up but as soon as I stop giving it gas it stalls. Car sat for a couple months then when I went to use it I went a 1/2 mile when it started to stall. Now it stalls as soon as I let up on the gas. Any ideas Thanks Bill


Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Nov 25, 2009, 4:59 PM

Post #2 of 13 (1872 views)
Re: stalling Sign In

Bill; If the vehicle sat that long, it's possible that the battery was low? Or, dead? If the computer loses battery voltage long enough, it will erase it's KAM (keep alive memory) and will have to 'relearn' idle stratedgies. After about 10-15 miles of normal driving, should correct it. There is a specific 'drive cycle' for this, but usually, just driving it will work.
If this isn't the case, could be as simple as a dirty or sticky IAC (idle air control) motor. These can be cleaned.
Loren
SW Washington


Bill45
Novice

Nov 26, 2009, 2:27 AM

Post #3 of 13 (1864 views)
Re: stalling Sign In

Battery never died, in fact it is very strong. The car starts as soon as you turn the key. Where & what is the idl control motor & how do you clean it? Thanks Bill


DanD
Veteran / Moderator
DanD profile image

Nov 26, 2009, 5:58 AM

Post #4 of 13 (1857 views)
Re: stalling Sign In

The IAC Motor is on the side of the throttle body; the picture below is just a generic picture; but it should give you an idea of what to look for.
I usually use a small bottle brush and a can of aerosol air intake cleaner; too clean the motor and the bore that the motor sits in.
While you’re at it prop open the throttle and clean the throttle plate and the throttle bore.

Dan.



Canadian "EH"






(This post was edited by DanD on Nov 26, 2009, 5:59 AM)


Bill45
Novice

Nov 29, 2009, 4:48 PM

Post #5 of 13 (1809 views)
Re: stalling Sign In

Frown Removed Idle air control & sprayed it with Carb cleaner ( all I had) Realized car only starts when I give it gas. Had my wife turn the key (no gas) while I looked at the butterfly, it didn't open. There is also some slack in the cables. Thanks Bill


DanD
Veteran / Moderator
DanD profile image

Nov 29, 2009, 5:18 PM

Post #6 of 13 (1806 views)
Re: stalling Sign In

The IAC doesn’t open the throttle; it controls the amount of air that is allowed to by-pass around the throttle plate(s).
The plunger type looking thing at the end of the IAC is extended or retracted; which changes/adjusts the idle speed.

Dan

Canadian "EH"






Bill45
Novice

Nov 29, 2009, 8:43 PM

Post #7 of 13 (1797 views)
Re: stalling Sign In

I am lost here. Doesn't the IAC move the throttle plate to let air in? Thanks Bill


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Nov 30, 2009, 3:47 AM

Post #8 of 13 (1791 views)
Re: stalling Sign In

No, it does not. It controls air flow through another passage unrelated to the throttle plate.



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



DanD
Veteran / Moderator
DanD profile image

Nov 30, 2009, 7:05 AM

Post #9 of 13 (1784 views)
Re: stalling Sign In



Sorry for the crappy drawing but it should show you what we mean?

Dan.

Canadian "EH"






Bill45
Novice

Nov 30, 2009, 8:01 AM

Post #10 of 13 (1777 views)
Re: stalling Sign In

The IAC does not have a stem into the throttle. Instead when I take it off there is a stem sticking out of the throttle housing. Is that normal? Thanks Bill


DanD
Veteran / Moderator
DanD profile image

Nov 30, 2009, 9:28 AM

Post #11 of 13 (1773 views)
Re: stalling Sign In


According to my buyers guide this is what it should look like? Maybe yours is broken off and is in two pieces; sure would answer the stalling issue?

Dan.

Canadian "EH"






Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Nov 30, 2009, 10:36 AM

Post #12 of 13 (1766 views)
Re: stalling Sign In

Sounds like it came apart....



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



Bill45
Novice

Nov 30, 2009, 11:46 AM

Post #13 of 13 (1759 views)
Re: stalling Sign In

Must be braken off. Mine doesn't have the spring or bullet shaped head. But there is a stem sticking out of the intake body. Will buy a new 1 & hope I can get the piece out of the intake body. Thanks For all you help. Bill






 
 
 






Search for (options) Privacy Sitemap