|
| | |
|
aaronburch8s
Novice
Jan 29, 2016, 8:26 PM
Post #1 of 14
(1869 views)
|
Hi i'm not to familiar with these forums. but I’m having a problem with an 09 Pontiac G6, with the 3.5L.95000.miles having trouble with the security lockout. The car ran fine last saturday night and when we went to start it sunday morning it wouldn't start, I have everything when we turn on the ignition but will not turn over engine. we took the starter off and had it tested at the local parts house and it checked out good, i did a load test on the battery and found it was bad so we replaced it, i get a Error code where the odometer is, I’ve tried the reprogram for 10 minutes that didn’t work. I’ve tried to hook up my scanner but it says error and won’t give me a code. i have checked all the fuses and computer plugs and everything is ok there. it has a remote start but when i try using it, all works good until its time to start then it starts honking and lights flashing. I’m up for any suggestions. I’m sorry if this isn’t the correct way to ask for help. thanks
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 29, 2016, 8:45 PM
Post #2 of 14
(1865 views)
|
What sort of error code are you seeing on the odometer? Have you tried using a professional level scan tool to get codes read? ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jan 30, 2016, 2:15 AM
Post #3 of 14
(1857 views)
|
Welcome - you're doing fine. Quoting you " >>it has a remote start but when i try using it, all works good until its time to start then it starts honking and lights flashing. I’m up for any suggestions.<<" ********************** Do you know if that is aftermarket or a factory installed feature? Aftermarket ones push 100% failures and if hacked into wiring who knows what troubles? Note on the parts outlets: They are really there to sell parts not be mechanics and most are NOT. You've tested a starter and think it's good and tested a battery and replaced it because it was determined bad by people who may not know crap about it. Just take the parts to a grocery store you stand a better chance. It's nice these places offer these services but with a grain of salt with what they say. It's always up to you or a tech to determine what needs what the parts outlets job is to sell parts you ask for and more if they can which is their job. My guess is this remote starter has failed as now when you are actually in it the behavior is like an alarm that you are stealing it. Great. IMO the job may be finding the right place to take all that crap out and restore wiring to factory OE condition with tools and info on putting it back as intended, T
|
|
| |
|
aaronburch8s
Novice
Jan 30, 2016, 6:48 PM
Post #4 of 14
(1837 views)
|
It says Error that's it. Yes I've hooked up to a Modis scanner not getting anything.
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 30, 2016, 6:51 PM
Post #5 of 14
(1832 views)
|
If your Modis can't communicate with the cluster, then the cluster may be bad. It is part of the security system. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
aaronburch8s
Novice
Jan 30, 2016, 6:55 PM
Post #6 of 14
(1830 views)
|
Thank you for responding. I have a load tester I use at work for the battery I since have crossed the starter terminals and I can start it doing it that way. But will not work through the ignition. The remote start is factory installed. I hooked it up to a Modis scanner and it's not showing me any codes. It does connect with the Ecm and Bcm. I was wondering if this has a fuel pump shut off? If so where would the reset be?
|
|
| |
|
aaronburch8s
Novice
Jan 30, 2016, 6:57 PM
Post #7 of 14
(1829 views)
|
Is there a way to reset the security mode ?
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 30, 2016, 7:05 PM
Post #8 of 14
(1824 views)
|
The security system on this car doesn't disable the starter. It disables the fuel injectors. The circuit just needs to be troubleshooted following a wiring diagram. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
aaronburch8s
Novice
Jan 31, 2016, 2:00 PM
Post #9 of 14
(1809 views)
|
thank you, when i hooked up Modis i was getting a responce from the PCM and BCM but still no codes i was able to get the car to start by turning the ignition on and jumping the starter but did not fix or give any codes i have pulled the ignition out to see if i can test it to see if the circut board is bad.i dont know if there is a way to do this but ill see if i can find something out. any other sugestions?
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 31, 2016, 2:06 PM
Post #10 of 14
(1805 views)
|
Like I said, troubleshoot the circuit. If you don't know how, then you'll just have to pay someone to do it for you. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
aaronburch8s
Novice
Feb 1, 2016, 8:53 PM
Post #11 of 14
(1782 views)
|
Thank you for the schematic it will help a bunch. i talked with someone about the key and the chip it has in it. do you know of a way to test the key to make sure its not the problem?
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Feb 2, 2016, 2:57 AM
Post #12 of 14
(1774 views)
|
As I already told you, the security system does not effect the starter. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
aaronburch8s
Novice
Feb 3, 2016, 6:06 PM
Post #13 of 14
(1757 views)
|
ok thank you again. i appreciate all your help
(This post was edited by aaronburch8s on Feb 3, 2016, 6:07 PM)
|
|
| |
|
aaronburch8s
Novice
Feb 11, 2016, 7:34 PM
Post #14 of 14
(1708 views)
|
Ok heres an update on the G6. i took it to a GM dealer and they say that the key is not reading with the ignition and the ECM is faulty.. so i wanted to say thank you to everyone who helped me out with my problem. and i hope this information will help anyone who is having the same issues. i wanted to say that i think ths is a great site and i highly rate it.
|
|
| |
|