|
|
|
1998 ford windstar---overdrive light blinking---
|
|
|
| |
|
|
Guest
Anonymous Poster
May 5, 2008, 6:36 PM
Post #1 of 8
(9545 views)
|
|
1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
hellow people, for the last couple of days when driving the overdrive light blinks no stop. pushing the button does nothing. until the van is shut off. then after starting its off and i can push the button and it stays lit without blinking. went to auto zone and had engine codes read and nothing seemed to pertain to the transmission. decided to do trans fluid and filter change because of the light blinking. this seems to have stopped the light from blinking but when shifting into overdrive the rpm needle seems to be slowly slipping into the shift. what do you think?
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
May 6, 2008, 12:11 AM
Post #2 of 8
(9540 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
For right now, double check that the fluid if properly full. What did the old fluid look like? The change making the light straighten out is encouraging but the slipping isn't
T
|
|
| |
|
|
way2old
Veteran
/ Moderator
May 6, 2008, 4:40 AM
Post #3 of 8
(9536 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
If the OD light was blinking, there should have been a code stored in the PCM. Have codes read again and look ror a P07xx series codes.
Being way2old is why I need help from younger minds
|
|
| |
|
|
Guest
Anonymous Poster
May 6, 2008, 11:05 AM
Post #4 of 8
(9531 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
codes read
p1537 p1538 pp0133 p1131 p1132 p0301 p1000 p0734
|
|
| |
|
|
dave284
Enthusiast
/ Moderator
May 6, 2008, 3:19 PM
Post #5 of 8
(9527 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
p1000= monitor testing incomplete.
po734= incorrect gear ratio, trans slipping.
po301= cylinder #1 misfire.
p1131 & p1132= 02 sensor bank 1.
po133= 02 sensor air fuel ratio is not being adjusted by the 02 sensor or the computer.
p1537 & p1538 = intake manifold runner control stuck open.
|
|
| |
|
|
dave284
Enthusiast
/ Moderator
May 6, 2008, 3:24 PM
Post #6 of 8
(9524 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
http://www.youtube.com/watch?v=YgikQ8s6Va0 From what I understand this affects the 02 sensors...check this clip out...it might aid in your problem.
|
|
| |
|
|
way2old
Veteran
/ Moderator
May 6, 2008, 3:39 PM
Post #7 of 8
(9523 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
Go det 'em Dave.
Being way2old is why I need help from younger minds
|
|
| |
|
|
dave284
Enthusiast
/ Moderator
May 6, 2008, 5:08 PM
Post #8 of 8
(9521 views)
|
|
Re: 1998 ford windstar---overdrive light blinking---
|
Sign In
|
|
well...I try, easy questions get anwsered by so many these days....not much room for my 2 cents worth
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
