|
|
swiss420
New User
Mar 28, 2008, 8:43 PM
Post #1 of 2
(3057 views)
|
|
PCV VALVE HELP NEEDED
|
Sign In
|
|
I have a 1986 Honda Accord with the 2.0 engine with a 2 bbl carb. I need to change my pcv valve but I cannot get the old one out. It has the type that is pull-out /push-in. Any suggestions on how I can remove the old one.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 29, 2008, 3:20 AM
Post #2 of 2
(3053 views)
|
|
Re: PCV VALVE HELP NEEDED
|
Sign In
|
|
Positive Crankcase Ventilation (PCV) Valve
Honda Accord/Prelude 1984-1995 Repair Guide 
See Figure 1
The engine is equipped with a Positive Crankcase Ventilation (PCV) system in which blow-by gas is returned to the combustion chamber through the intake manifold and/or the air cleaner. Blow-by gas is the portion of the normal combustion gasses that get by the piston rings and pressurize the lower part of the engine. If not vented, these gasses will eventually force their way through gaskets at the top or bottom of the engine, causing improper running and/or fluid leaks.
The PCV system captures these gasses and routes them back into the engine where they can be reburned. The PCV valve controls the flow into the engine. If the valve sticks closed, excess pressure can build in the engine. If it sticks open, too much gas may be admitted to the engine, causing a rich mixture, black exhaust smoke and generally poor driveability.
Fig. 1: PCV valve and breather hose location on 1989 Preludes. All models are similar
The function of the PCV valve should be checked every 60,000 miles (96,000 km) or whenever an emission-related problem is being diagnosed. As long as the valve is functioning properly, it does not need replacement.
TESTING
See Figures 2 and 3
Inspect the hoses for cracks, leaks or clogging. With the engine running at warm idle, use fingers or pliers to gently pinch the PCV hose running to the valve. You shoud hear the valve click when the hose is pinched.
On some models, it will be necessary to remove the air cleaner support brace to access the PCV valve.
Fig. 2: If necessary, remove the nuts securing the brace, then remove it from the air cleaner
Fig. 3: Using your fingers or pliers, gently pinch the PCV hose running to the valve
If no clicking is heard, inspect the rubber grommet around the valve for cracks or damage. If the grommet is good, replace the valve.
REMOVAL & INSTALLATION
To remove the valve, disconnect the hose and pull the valve from the grommet. Install the new valve and connect the hose. Attempting to clean the valve is not recommended; always replace it. Install the new valve firmly into the grommet. Connect and secure the hose.
Rubber grommet and or hose may need to be replaced at the age of this car. Make sure you have or can get them before breaking them,
T
(This post was edited by Tom Greenleaf on Mar 29, 2008, 3:25 AM)
|
|
| |
|
| | |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 