|
|
gazerball
New User
Sep 5, 2011, 8:05 AM
Post #1 of 8
(2040 views)
|
1999 dodge durango 5.9 189,000 miles Compressor clutch will not engage. I have good ground from clutch , but no power. Have checked continuity thru entire control system. Only open found in in the cold temp cut-out. Not sure if it should be N/O or N/C. Dodge dealer tells me N/O, but this makes no sense. PLEASE HELP
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Sep 5, 2011, 8:11 AM
Post #2 of 8
(2036 views)
|
#1 is to take a static pressure of the system at least. These a famous for evaporator leaks and with low or no static pressure whole A/C system will shut down, T PS: You should see static pressures like this............
(This post was edited by Tom Greenleaf on Sep 5, 2011, 8:16 AM)
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Sep 5, 2011, 8:30 AM
Post #3 of 8
(2014 views)
|
That is a 3 wire sensor. It receives power in on the WT wire. It then should have continuity (not necessarily power) between the DB/WT and the DB/YL wires. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
gazerball
New User
Sep 5, 2011, 8:31 AM
Post #4 of 8
(2012 views)
|
ambient temp 63 degrees Static pressure is 60in. Hg
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Sep 5, 2011, 8:35 AM
Post #6 of 8
(2003 views)
|
Hg is vacuum. Looking for PSI which I think you meant which is enough so there's some electrical problem involved, T
|
|
| |
|
gazerball
New User
Sep 5, 2011, 8:52 AM
Post #7 of 8
(1985 views)
|
where is the low temp cut-out switch located
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Sep 5, 2011, 8:55 AM
Post #8 of 8
(1982 views)
|
Inside the evaporator case but the wiring should come from outside. You should be able to access them by removing the glove box. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Sep 5, 2011, 8:56 AM)
|
|
| |
|