|
|
|
1988 ford ranger flywheel
|
|
|
| |
|
|
kbruce
Novice
Jun 19, 2008, 12:31 PM
Post #1 of 6
(6982 views)
|
1988 ford ranger flywheel
|
Sign In
|
|
I have a 1988 for ranger and it's just about to chew up the 2nd starter within the last few months. I crawled under and took a look at the teeth on the flywheel, they seem pretty scared up and I'm almost positive that is the problem. In order to replace that I'm going to have to drop the transmission and replace the flywheel ring gear and clutch all at the same time. I'm the first to admit that my mechanical knowledge is pretty basic. This seems like a pretty big job and I'm a little nervous. I have all the parts and a fresh starter, and a manual for the pickup but any other tips or resources would be a great help.
thanks
|
|
| |
|
|
dave284
Enthusiast
Jun 19, 2008, 6:08 PM
Post #2 of 6
(6977 views)
|
|
Re: 1988 ford ranger flywheel
|
Sign In
|
|
I would also replace the T.CONVERTER pump seal and the rear main oil seal while you have the trans removed.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 19, 2008, 6:56 PM
Post #3 of 6
(6968 views)
|
|
Re: 1988 ford ranger flywheel
|
Sign In
|
|
Dave - I think they mean a standard trans and real flywheel. I might try shims to increase clearance as it seems starter drive was just getting way too close. Hey - I'm not the one looking at it to decide if the worn ring gear can still last or not.
It's been about 100 years since I've even seen a gear replaced and I think you bust off the ring gear, put flywheel in a freezer and heat new ring gear and when the same temp they will stick like welded - probably wrong on that - check on that.
Pic below shows a way to adjust starter drive gear to ring gear....with wire and shims to change position not shown,
T
(This post was edited by Tom Greenleaf on Jun 19, 2008, 6:57 PM)
|
|
| |
|
|
dave284
Enthusiast
Jun 20, 2008, 7:25 AM
Post #4 of 6
(6959 views)
|
|
Re: 1988 ford ranger flywheel
|
Sign In
|
|
Oh. sorry about that, eyes aren't as good as used to be .
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 20, 2008, 9:15 AM
Post #5 of 6
(6958 views)
|
|
Re: 1988 ford ranger flywheel
|
Sign In
|
|
Didn't you get the company issued eyeball! Way2Old got the crystal ball so we have to rely on this sucker!
Just busting you,
T
|
|
| |
|
|
kbruce
Novice
Jul 24, 2008, 8:57 AM
Post #6 of 6
(6913 views)
|
|
Re: 1988 ford ranger flywheel
|
Sign In
|
|
Thanks for the tip. I found that they don't make shims for my starter any more but was able to cut and bend another set, worked out great thanks!!
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
