|
|
1998 Chrysler T & C van Transmission
|
|
|
| |
|
|
music9704
Novice
Nov 10, 2016, 11:27 AM
Post #1 of 13
(2528 views)
|
1998 Chrysler T & C van Transmission
|
|
|
I just got this van. Once the trans warms up it acts like its in neutral.
Only drove it once, I went two blocks and it quit moving. It was more like I put in it neutral. I can start the van, not put in in gear until it warms, and again it will not move. I know these have known problems, however I cannot get the fault codes.
my questions are. will a actron auto scan give transmission codes?
If no codes are showing, does this sound like a solenoid pack problem?
I hate to change transmission fluid and filter on a bad trans, but I have read this can fix issues. Especially if the prior owner used wrong type of fluid. How do I get the fluid out of the torque converter? Can I undo one of the lines and let it pump out?
|
|
| |
|
|
kev2
Veteran
Nov 10, 2016, 11:56 AM
Post #2 of 13
(2521 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
start with basics- fluid and codes -
fluid level and condition - a quick easy look.
Codes - ask actron about what the capability if their tool is - often online tech support.
>>> What happens when you try to connect?
>>> Try the key trick - ign key on off on off on see if codes display in odometer... I think 98 will allow this quick ck.
Fluid and filter - always a hail mary - dropping pan for visual would make sense...
do NOT worry about draining converter and flushing purging at this time.
|
|
| |
|
|
gsferraro
Veteran
Nov 10, 2016, 12:27 PM
Post #3 of 13
(2514 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Hello,
Your transmission filter is clogged. drop the pan see how bad it is, if the filter is colgging, then something is coming apart. Gary
(This post was edited by gsferraro on Nov 10, 2016, 12:28 PM)
|
|
| |
|
|
music9704
Novice
Nov 10, 2016, 12:29 PM
Post #4 of 13
(2513 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Thank you, I'm working on it this weekend so I'll try the scan tool. I will need to borrow it from brother in law. I'll go ahead and drop the pan and check the filter..... I'll also check for odometer codes, thanks I didn't know this.
|
|
| |
|
|
gsferraro
Veteran
Nov 10, 2016, 3:01 PM
Post #5 of 13
(2507 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Hello,
ok sounds good, if your going to drop the pan see how bad it is, also if you do scan it let me know what codes yopu have. Gary
Do you know what type of scanner he has?
|
|
| |
|
|
music9704
Novice
Nov 11, 2016, 10:31 AM
Post #7 of 13
(2492 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
OK after reading some info on this; I may tear the trans apart before I rebuild. From what I understand the larger metal shavings could be a problem. The sludge is from the clutches.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Nov 11, 2016, 12:36 PM
Post #8 of 13
(2486 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
I'd say your better off getting a reman with a warranty. If it is full of metal shavings, the cost of parts and labor time involved will probably exceed another one. That is my opinion.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
music9704
Novice
Nov 14, 2016, 5:09 PM
Post #10 of 13
(2463 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
After a few new sockets, 1 broken wrench, 1 broken bolt  the transmission is now out. It wasn't to bad, other than the broken trans mount bolt. I'm not sure if I can ez it out. I'm going to tear into transmission tomorrow.
There is a 41TE (604) Rebuild Procedures pdf online. I'm not sure if hyperlinks are allowed but here is the address for the pdf. uscars.biz/uscars/extras documents/ATRA_Chrysler_41TE_604_Rebuild_Procedures.pdf
If you try to repair or rebuild a 41te trans read below.
The pdf helped, but I found a few youtube videos were better. Search 41te teardown inspection, and also 41te repair.
(This post was edited by music9704 on Nov 16, 2016, 5:00 PM)
|
|
| |
|
|
gsferraro
Veteran
Nov 14, 2016, 6:59 PM
Post #11 of 13
(2456 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Hello,
Im sure there is, ATRA is a tech service, im sure they have something. Let me know how it goes. Gary
|
|
| |
|
|
music9704
Novice
Nov 16, 2016, 4:50 PM
Post #12 of 13
(2438 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Thanks Gary, The rear planetary is shot. Two of the pins holding the gears are broken. the other two are worn. I found one for $65. I'm going to double check everything one more time and put it back together. I think the front was hit, it looks like maybe someone ran over something. Could have caused the problem, because everything else looks good.
|
|
| |
|
|
gsferraro
Veteran
Nov 16, 2016, 5:15 PM
Post #13 of 13
(2432 views)
|
|
Re: 1998 Chrysler T & C van Transmission
|
|
|
Hello,
The rear planet meshes with the sungear, look at all those gears carefully, I dont feel this happened from a hit, i feel this happened beacuse the trans is junk(lol)at one point this was the number one selling overhaul kit. They even changed the name of this unit, started out as A604, then changed the name to 41TE(but the trans is the same) Let me know how you do, im here if you have questions during assembly. Gary
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
@100%sure occult //+2348028911519 // join Odunga Brotherhoods Occult today.
%{{+2348028911519}} ©© Do money ritual die @85
™®©+2348028911519 {©®} <>I WANT TO JOIN OCCULT FOR POWERS AND WEALTH
/!! (+2348028911519 (()) & __JOIN SECRET OCCULT WITHOUT HUMAN KILLING
\\[+2348028911519] \\BEST MONEY RITUAL OCCULT IN NSUKKA ENUGU NIGERIA
Tierod end change caused some kind of leak
Grounding Cable, 2017 Jeep Renegade Trailhawk
