|
|
|
97 Mercury Mystique overdrive problem
|
|
|
| |
|
|
blt
User
Feb 7, 2017, 10:08 PM
Post #1 of 13
(2253 views)
|
|
97 Mercury Mystique overdrive problem
|
Sign In
|
|
My Mercury has 68,000 miles. The transmission was serviced recently. It shifts smoothly into all gears around town and you wouldn't know there is a problem.
At highway speeds of 60+ in overdrive, it slips as the tach revs and seems to search for a gear to downshift. This happened intermittently, about 4 times on an 80 mile trip.
Could this be the transmission range sensor or some other sensor issue? No codes appear.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Feb 8, 2017, 5:37 AM
Post #2 of 13
(2231 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Was an OBD2 generic scanner used to see if there were codes? There are two parts to the engine computer, the OBD side and the manufacture side. The manufacture side is more concise, but it requires a high end scan tool to access. There may be manufacture codes stored. Someone needs to monitor TCC slip speed, PRDNL status, and other PIDs and hopefully catch what is going on.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
gsferraro
Veteran
Feb 8, 2017, 2:52 PM
Post #3 of 13
(2215 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Hello,
Would you say this may be dropping from 4th to 3rd? Gary
|
|
| |
|
|
blt
User
Feb 26, 2017, 12:02 AM
Post #4 of 13
(2166 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Sorry for the slow response. Was traveling and am back.
I took it to a transmission guy and he said he couldn't diagnose properly because the engine was not running properly. Codes are triggered when this car has one little stutter at idle, but does not effect running above 1000 RPM. However he said replace the plugs wires and fuel filter before any trans work, so I said no thanks. I did change the plugs and no codes are present after several weeks. Aside from a transmission service and $100 for a non-diagnosis, I'm back to square one. It still intermittently floats back and forth between overdrive and the next gear.
|
|
| |
|
|
blt
User
Feb 26, 2017, 12:04 AM
Post #5 of 13
(2164 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Fluctuates intermittently from overdrive to the next gear and back up to overdrive.
(This post was edited by blt on Feb 26, 2017, 12:05 AM)
|
|
| |
|
|
gsferraro
Veteran
Feb 26, 2017, 7:34 AM
Post #6 of 13
(2154 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Hello,
This trans is a CD4E, there is no pan but there is a side cover(close to radiator) just above the side cover on the top of the trans is a switch that is attached to the linkage called the M.L.P.S (manual lever postion sensor) If this is faulty it can cause the trans to drop from 4th to 3rd, it may produce codes or it may not, you may want to look into that. Gary
|
|
| |
|
|
blt
User
Feb 26, 2017, 8:07 PM
Post #7 of 13
(2139 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Thank you Gary,
I will check your line of thought out.
|
|
| |
|
|
gsferraro
Veteran
Feb 27, 2017, 3:28 AM
Post #8 of 13
(2128 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Ok, sounds good, the switch has been updated, so if you do change it you will get the updated switch. If the early switch is on your car, the updated looks different
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Feb 27, 2017, 3:39 AM
Post #9 of 13
(2128 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
BLT - Quote from post #4">I took it to a transmission guy and he said he couldn't diagnose properly because the engine was not running properly.<"
Take note of that. If the engine isn't running properly know that is has to first or trans wouldn't know "Jack" about how to shift properly. You had it at a shop so what was the problem found on why is doesn't run well?
T
|
|
| |
|
|
blt
User
Feb 27, 2017, 11:07 AM
Post #10 of 13
(2117 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Tom,
From DAY ONE this car shook (some vibration in steering wheel) at idle due to poor harmonic balancing. Ford had no answer, so I lived with it. The mechanic either misunderstood this as the "engine" was running poorly, or was just looking for more work.
I was not going to pay an additional bill to replace plugs, wires, and fuel filter as this was unnecessary. I replaced the plugs solely on the mileage, even though the gap and plug condition did not require it, and it was not missing.
My original question about the transmission range sensor (neutral safety switch) had some confirmation so I will spend the $40 and give this a shot first.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Feb 27, 2017, 11:27 AM
Post #11 of 13
(2113 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
OK - How are you sure that's it? You can frequently see those wobble and they can fall off! Game over if it does. I can't understand how you said Ford couldn't find that and strongly suggest to take care of that. OMG - so bad you feel it in steering wheel? This could be causing a host of problems up to real damage so until smooth as it should be if it can at all this is critical!
Tom
|
|
| |
|
|
blt
User
Feb 27, 2017, 12:13 PM
Post #12 of 13
(2109 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
Above 750 rpm the engine is absolutely smooth/no vibration transmitted thru steering wheel.
Transmission has always shifted properly without any issues until now.
Not sure TRS is it but it's in inexpensive fix and worth the gamble as I've read and seen on youtube.
|
|
| |
|
|
blt
User
Mar 9, 2017, 1:24 AM
Post #13 of 13
(2070 views)
|
|
Re: 97 Mercury Mystique overdrive problem
|
Sign In
|
|
BINGO!!! The manual lever position sensor (neutral safety switch) was the problem.
Finally had a warm day to work outside!
It took some effort breaking the 5/16 bolts loose in a very awkward/tight space but was finished in 1 hour.
Thanks to all who responded, especially Gary who nailed it!
Brad
(This post was edited by blt on Mar 9, 2017, 1:37 AM)
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
