|
|
|
Transfer Case or Transmission problem???
|
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 12:21 PM
Post #1 of 26
(3474 views)
|
|
Transfer Case or Transmission problem???
|
Sign In
|
|
I just acquired a 94 model F150 XLT which was stuck in 4 lo. I managed to fix the fact it wouldn t shift through the 4WD at the shifter but when I get it into 4 Hi it is OK until you try to go up through the gears. It seems to just disconnect from the transmission itself (doesn t make a noise like its fallen out of gear, just revs and doesn t bite). I can go through the gears in 4 lo so I don t understand what the problem is. Is it a transfer case issue or a transmission issue... Any ideas/information would be much appreciated.
Body style: REGULAR CAB PICKUP 2-DR
Brake - front: Disc
Brake - rear: Drum
Driveline: 4WD
Engine series: V-8 5.0L
Engine type: V8, 5.0L
Fuel tank: 18.20 gallon / 68.9 liter
Fuel type: Gasoline
Safety restraints: Driver airbag, active belts
Tires: 235/75R15
Trim level: S Reg. Cab Short Bed 4WD
|
|
| |
|
|
gsferraro
Veteran
Mar 8, 2015, 1:35 PM
Post #2 of 26
(3451 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
So if you put this in 4 hi the car does not move? are you syre your not putting the transfer case in neutral? then the car wont move.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 8, 2015, 1:37 PM
Post #3 of 26
(3450 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
OK - So you just got this and it was stuck in 4WD lo. What did you do that fixed that with the shifter I take it type on the floor? Not my strong suit but don't think the selector is adjusted properly so far and might be too close to plain "N" where you get nothing,
T
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 2:51 PM
Post #4 of 26
(3446 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
it goes into 4hi and 2wd but whenever you shift gears from 1st to 2nd it misses and just goes into neutral gear.
|
|
| |
|
|
gsferraro
Veteran
Mar 8, 2015, 3:47 PM
Post #5 of 26
(3442 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Ok, so this shifts 1st to 2nd and when it should go into 3rd it goes into neutral? if so, you have a trans problem. Gary
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 4:29 PM
Post #6 of 26
(3436 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
It only slips out of gear when in 4hi and 2wd. I can go up and down in 4lo with no problems. I just took it down the road and got it into 4hi and 2wd. Got all the way up through 4th but as soon as I got to the end of the road and had to stop it completely lost and gearing at all.
|
|
| |
|
|
gsferraro
Veteran
Mar 8, 2015, 5:06 PM
Post #7 of 26
(3429 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
As a test when it stops moving im assuming you also have no reverse, turn the car off for about 3 minutes, than start it back up again and see what you have. Gary
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 5:14 PM
Post #8 of 26
(3422 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Doesnt seem to do much. Still have to take it back to 4lo to get moving again. After running it for a while in 4lo I can put it back into 4hi and get movement sometimes, just not every time and again just until it decides to stop again
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 8, 2015, 5:19 PM
Post #9 of 26
(3419 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
You stated you just acquired this. Did you ask the previous owner why the transfer case was stuck in 4 lo before you got it? Which transmission does this have?
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 5:24 PM
Post #10 of 26
(3415 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
It was sold to a dealer and he didn't know why it was this way apparently. I'm not sure what transmission it has, stick shift obviously but that's all I know sorry. Yeah sad it probably just needs a new transfer case as that's where the grinding sound seems to come from when it slips out of gear
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 8, 2015, 5:31 PM
Post #11 of 26
(3413 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Well, if you can shift through all gears without it neutraling out in 4 LO and you know the clutch isn't slipping, your probably right that there is something going awry in the transfer case.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 5:33 PM
Post #12 of 26
(3411 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Would the transfer case cause a grinding sound and slipping out of gear? I mean would it be something worth rebuilding or just get a new transfer case
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 8, 2015, 5:36 PM
Post #13 of 26
(3409 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Honestly, your probably better off getting another one. It would probably be cheaper in the long run. If you find one in a salvage yard, make sure it comes with some type of warranty.
There are three possibilities of transfer cases. Is this electronic or manual type transfer case?
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Mar 8, 2015, 5:39 PM)
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 5:39 PM
Post #14 of 26
(3406 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
I know where I can get one for around 100/150 dollars. Does that seem like a fair price for one? I'm very new to trucks and 4wd so I have no idea on these things
|
|
| |
|
|
gsferraro
Veteran
Mar 8, 2015, 5:49 PM
Post #15 of 26
(3404 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
This is a standard shift not an automatic? Gary
|
|
| |
|
|
eagles_wing13
User
Mar 8, 2015, 5:51 PM
Post #16 of 26
(3403 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Yeah stand shift. Both transmission and transfer case are manual operated
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 8, 2015, 6:01 PM
Post #17 of 26
(3398 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Sure a transfer case can jump out and grind.
Could be an issue with the shift linkage not being adjusted correctly, drive shaft slip yokes being dried up and not sliding, trans mount that is broken and allowing the transfer case to jump up and knock it out of a shift mode, and/or something internal; i.e. bad sliding clutch hub or gear clutch teeth damaged.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Mar 8, 2015, 6:02 PM)
|
|
| |
|
|
eagles_wing13
User
Mar 9, 2015, 4:34 PM
Post #18 of 26
(3362 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
I've got this far, just wondering how do you disconnect the rear drive shaft. Do I have to undo the 4 bolts at the back axle? Any ideas?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 9, 2015, 4:46 PM
Post #19 of 26
(3358 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Mark the drive shaft and pinion flange with paint or something, so they line back up the same way you take them off. Then remove the bolts holding the drive shaft to the rear end pinion flange. Once you get that undone, slide the drive shaft out of the transfer case.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Mar 9, 2015, 4:49 PM)
|
|
| |
|
|
eagles_wing13
User
Mar 9, 2015, 5:05 PM
Post #20 of 26
(3353 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Thank you for the speedy reply.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 9, 2015, 5:08 PM
Post #21 of 26
(3352 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
I just happened to be near the computer while I was making my gourmet meal. Looks like it is going to be another dutch oven night under the covers...hehehe
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Mar 9, 2015, 5:09 PM)
|
|
| |
|
|
eagles_wing13
User
Mar 9, 2015, 5:16 PM
Post #22 of 26
(3346 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
My wife would kill me if I ate too many of those...you are making me feel hungry however he he.
|
|
| |
|
|
eagles_wing13
User
Mar 13, 2015, 5:38 PM
Post #23 of 26
(3318 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Another quick question in case someone can tell me. Got everything put back on and everything works in terms of the transfer case itself. Only thing now is i have no 4wd indication on the dashboard and i have no idea where the vent hose needs to connect to. The new transfer case didn't even have the hose attached and my old one was broken off.
|
|
| |
|
|
gsferraro
Veteran
Mar 13, 2015, 6:15 PM
Post #24 of 26
(3303 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Is it in fact going into 4wd since theres no light on the dash? I believe there should be a little vent tube that the rubber hose attaches onto, do you see a small metal or plastic vent tube sticking out anywhere?
|
|
| |
|
|
eagles_wing13
User
Mar 13, 2015, 6:19 PM
Post #25 of 26
(3301 views)
|
|
Re: Transfer Case or Transmission problem???
|
Sign In
|
|
Its all shifting into and out of 4wd perfectly. I figure the switch itself is just broken and needs replacing. The metal vent is all I have. No hose attached to it. if i get a hose where does it connect to? or does it just vent to no where?
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Strut spring orientation and strut mount tension nut
1
