|
|
|
Transmission troubleshooting questions.
|
|
|
| |
|
|
HermanM96
New User
Aug 26, 2019, 6:37 AM
Post #1 of 6
(1518 views)
|
|
Transmission troubleshooting questions.
|
Sign In
|
|
2003 Chevy Monte Carlo SS 3.8 116,043 miles
Having some trans concerns. Recently started to shift mildly hard. Mostly from the stopped position into 1st gear. Checked the dip.stick. Nice color fluid as far as I can tell, but seeing black grease like color on the paper towel as well. The fluid is a little bubbly, and the bubbles are over the hot line for sure. Had a crack in my radiator last month. It was replaced. But Idk if the fluid was in the proper area at the get go. Any advice?
|
|
| |
|
|
gsferraro
Veteran
Aug 28, 2019, 4:24 PM
Post #2 of 6
(1489 views)
|
|
Re: Transmission troubleshooting questions.
|
Sign In
|
|
Hello,
Your engagement into drive is harsh or the 1-2 shift is harsh? have you scanned for codes? Gary
|
|
| |
|
|
HermanM96
New User
Aug 28, 2019, 5:44 PM
Post #3 of 6
(1481 views)
|
|
Re: Transmission troubleshooting questions.
|
Sign In
|
|
I don't have a scanner. It's when it's already in drive, then getting into that 1-2 gear getting going from a stop sign or stop light. I've been using my foot a little different on the peddle without having any problems though. Are bubbles a problem to be worried about. If I wanted to drain a little fluid out where would I do that from?
|
|
| |
|
|
gsferraro
Veteran
Aug 30, 2019, 5:52 PM
Post #4 of 6
(1443 views)
|
|
Re: Transmission troubleshooting questions.
|
Sign In
|
|
Hello,
You really need to have the car scanned, you may have an 1811 code for the transmission, this may or may not turn the check engine light on. Gary
|
|
| |
|
|
HermanM96
New User
Aug 30, 2019, 6:20 PM
Post #5 of 6
(1439 views)
|
|
Re: Transmission troubleshooting questions.
|
Sign In
|
|
Thanks Gary. I think I got a plan going forward. I posted on Reddit too and got a good bit of info. Mostly that I was overdue for my filter and fluid to be changed. And a good way to go about that with cleaning out the metal bits in the pan. I definitely want to get a scan too. My light has been on for a bit now since I've had it. I'm going to write that code down. Tahk you sir.
Dan
|
|
| |
|
|
gsferraro
Veteran
Aug 31, 2019, 1:28 PM
Post #6 of 6
(1414 views)
|
|
Re: Transmission troubleshooting questions.
|
Sign In
|
|
Hello,
Can't hurt to service the trans, but if shifting hard very possible the computer may be adding pressure so the trans will not slip, you would need a good scan-tool to see this info like a snap-on, if you have access to one go into data and look under T.A.P Cells (transmission adaptive pressure).
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
This isn't normal, right?
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
