|
|
Blaiz_EM1
New User
Nov 26, 2010, 9:46 AM
Post #1 of 2
(2233 views)
|
Ok, I have an 1995 olds Aurora, has about 141,000 miles. Last october I replaced the fuel pump and connector plug, next came the fuel pressure regulator. Turned out it was the idle speed control actuator that was causing all these problems. So I replaced that but when it was done I think the screw that pushes the accelerator was too loose therefore causing a constant high fuel pressure. Anyway, it broke down again, acting like its not getting any fuel. My real question is, is there a torque on that screw for the idle speed control actuator?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 26, 2010, 10:25 AM
Post #2 of 2
(2230 views)
|
That screw should never have been touched at all. That is the base idle setting and thewre is a specific procedure for setting that. It won't cause it to break down though.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 