|
|
lmorris11
New User
Jan 8, 2011, 11:26 AM
Post #1 of 4
(1525 views)
|
2001 monte carlo, 3.4 liter, LS,98000 miles, car will turn over but won't start, already had diagnostic on it and they said it was the fuel pump, i replaced the fuel pump and the fuel filter and it still doesn't start. Help
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 8, 2011, 11:51 AM
Post #2 of 4
(1519 views)
|
|
Re: car wont start
|
Sign In
|
|
Sounds like the people that did the diagnostic were wrong or there was a problem with the installation. Use a fuel pressure gauge and test for power and ground arriving at the pump.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
lmorris11
New User
Jan 8, 2011, 11:54 AM
Post #3 of 4
(1515 views)
|
|
Re: car wont start
|
Sign In
|
|
have done that, it has 50psi and the gray wire has power.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jan 8, 2011, 11:56 AM
Post #4 of 4
(1510 views)
|
|
Re: car wont start
|
Sign In
|
|
Then you're back to square one.
All "crank, no start" conditions are approached in the same way. Every engine requires certain functions to be able to run. Some of these functions rely on specific components to work and some components are part of more than one function so it is important to see the whole picture to be able to conclude anything about what may have failed. Also, these functions can ONLY be tested during the failure. Any other time and they will simply test good because the problem isn't present at the moment.
If you approach this in any other way, you are merely guessing and that only serves to replace unnecessary parts and wastes money.
Every engine requires spark, fuel and compression to run. That's what we have to look for.
These are the basics that need to be tested and will give us the info required to isolate a cause.
1) Test for spark at the plug end of the wire using a spark tester. If none found, check for power supply on the + terminal of the coil with the key on.
2) Test for injector pulse using a small bulb called a noid light. If none found, check for power supply at one side of the injector with the key on.
3) Use a fuel pressure gauge to test for correct fuel pressure, also noticing if the pressure holds when key is shut off.
4) If all of these things check good, then you would need to do a complete compression test.
Once you have determined which of these functions has dropped out,
you will know which system is having the problem.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
| | |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
