The self-starter was first invented in 1899, but the invention was impractical and then in 1903 it was patented in New York City. But by 1920, nearly every vehicle had a self-starter. It had replaced the hand-cranking.
There are a few different types of starters:
• Electric starter – this is the modern starter motor and it is a series wound direct current electric motor with a solenoid switch that is similar to a relay, mounted on it. When the low-current power from the starting battery is applied to the solenoid (this is usually through a key operated switch), it will push out a small pinion gear on the starter motor’s shaft and meshes it with the ring gear on the flywheel of the engine. The solenoid will also close high current contacts for the starter motor and it will start running. When the engine starts up, the key operated switch is opened and a spring in the solenoid assembly will pull the pinion gear away from the ring gear, and the starter motor will then stop. In modern starter motors there is a “bendix” – which is a gear and integral freewheel, or an overrunning clutch. This will enable the flywheel to automatically disengage the pinion gear from the flywheel when the engine starts.
• Pneumatic starter – This system consists of a geared turbine, an air compressor and a pressure tank. It is used particularly on trucks, but some gas turbine engines and Diesel engines use it as well. Here, compressed air released from the tank is used to spin the turbine, and through a set of reduction gears it will engage the ring gear on the flywheel. This is a lot like an electric starter would. Once the engine is running, it powers the compressor to recharge the tank.
• Auxiliary starter engine – sometimes on larger, high powered Diesel engines, there may be a small gasoline powered engine that is attached to the side as a starter. These were sometimes called pony engines. Sometimes they shared the same cooling system and oil supply. As the pony engine warmed up, it circulated warm coolant and warm oil in the diesel engine. It also made it easier to crank and it improved the service life.
