Latest Forum Post
03 alero no low speed blower
Good day everyone, I have a 2003 Olds a...
04 Chevy 2500hd tail light issues
Help!!! I have changed my combo switch...
1999 Grand Caravan Sport not starting.
Hi. I'm new here. I hope someone can hel...
Brake Seals Bulging
2021 Toyota Corolla LE 1.8l 65,000 mile...
Engine blew up after oil change, is mechanic responsible?
Hello, I have a 2007 Hyundai Elantra wit...
Changed pads and now brake pedel goes to the floor
I am not much of a mechanic, and needed ...
Equinox air conditioning issue, help please!
I have a 2020 Chevrolet Equinox that has...
2005 Maxima overheats only when idling but engine temp comes down immediately if I rev up the engine (even though car is stationary)
hello everyone, I own a 2005 Nissan M...
Brake & Turn Signal Out - One side only
2002 Ford Ranger 3.0 V6, 5-speed manual ...
Seeking Advice: Strange Noise in 2017 Nissan Versa Note, Mechanic Stumped
Hey everyone, A few weeks ago, my mom's...
|
|
chickenhouse
Enthusiast
Aug 6, 2011, 3:26 PM
Post #1 of 6
(3355 views)
|
5.3 Z71 codes are lean on bank 1 and bank 2. Codes are 171 & 174. Runs along fine, losses power and quits. Wait 10 or 15 mins, starts and runs fine again.
|
|
| |
|
chickenhouse
Enthusiast
Aug 6, 2011, 3:55 PM
Post #2 of 6
(3350 views)
|
Fuel pressure runs at 46 to 48 psi at idle.
|
|
| |
|
Discretesignals
Ultimate Carjunky
/ Moderator
Aug 6, 2011, 4:19 PM
Post #3 of 6
(3347 views)
|
What is fuel pressure when it stalls? Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 6, 2011, 4:35 PM
Post #4 of 6
(3339 views)
|
That fuel pressure is too low CH. If it's a "T" motor, it should be 55-62 If it's a Vin "Z", it should be 48 - 54 with no margin for error ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
chickenhouse
Enthusiast
Aug 6, 2011, 4:58 PM
Post #5 of 6
(3335 views)
|
Pretty much what we were thinking when pressure test came back low. I thought 50 -55 would have been good. Thanks guys!
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 6, 2011, 5:03 PM
Post #6 of 6
(3333 views)
|
Even that would be too low if it is a "T" motor. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|