|
|
|
Mercury tracer wont turn over
|
|
|
| |
|
|
Guest
Anonymous Poster
wranglerboy_18@yahoo.com
Aug 13, 2009, 7:30 AM
Post #1 of 11
(4067 views)
|
|
Mercury tracer wont turn over
|
Sign In
|
|
I have a 93 mercury tracer 1.9L with 157000 miles on it. I put a new battery in and tested it shows 700cca. The starter engages but cannot turn the engine over. Oil level and consistancy and color all look good. What could cause this?
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Aug 13, 2009, 7:40 AM
Post #2 of 11
(4062 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
What do you mean by "the starter engages but won't turn the motor over" ?
|
|
| |
|
|
Guest
Anonymous Poster
Aug 13, 2009, 7:43 AM
Post #3 of 11
(4061 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
you can hear the solinoid kick in like it locks up the gears to start turning the motor over but then does nothing. IF you wait a few mins and try again it will turn over but slowly
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Aug 13, 2009, 7:48 AM
Post #4 of 11
(4060 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
Ok. If you are just hearing a "click" you could be looking at a connection or cable issue. Make sure the both terminals are clean & tight and the cables don't look "swollen". After that you're probably going to have to do a voltage drop test on the cables to make sure there isn't excess resistance in the circuit............Also maybe take the battery back to where you got it & have them double check it..... Wouldn't be the 1st time I've seen a bad battery right off the shelve.....
|
|
| |
|
|
Guest
Anonymous Poster
Aug 13, 2009, 7:59 AM
Post #5 of 11
(4056 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
would it be easier and close to the same money to replace the cables from battery to the starter without testing. Or would the test help reveal other issues?
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Aug 13, 2009, 8:10 AM
Post #6 of 11
(4055 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
The test would revel if the part is the problem or not......... If you have the equipment it's alway cheaper to test than throw parts, running the test cost nothing but time...... If you are a good guesser, then it's easier & faster to throw parts than test......
(This post was edited by Sidom on Aug 13, 2009, 8:11 AM)
|
|
| |
|
|
Guest
Anonymous Poster
Aug 13, 2009, 8:18 AM
Post #7 of 11
(4052 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
got it. I don't have the equipment. I can get it to start once in a while so i can run it in to a shop if i have to
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Aug 13, 2009, 8:31 AM
Post #8 of 11
(4048 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
That does make it a little tougher..... If you're not going to use the tools than its a waste to spend $$ on them.....
The diag will probably be the cheaper route....... for that in the range of $20 - $40. If it's something you can do yourself then you not out too much....... Even as much as I dislike seein em rolll out after the diag it's all good.....
But definately do the stuff you can 1st..... clean the cables & if one is obviouly swollen with corrosion.....replace it.....
(This post was edited by Sidom on Aug 13, 2009, 8:32 AM)
|
|
| |
|
|
Guest
Anonymous Poster
Aug 13, 2009, 1:36 PM
Post #9 of 11
(4039 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
cleaned all terminals up and looked good the car fired right up let it run a few mins shut it off and not it just clicks onces but doesn't sound like it is engaging the motor to turn it over
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Aug 13, 2009, 2:30 PM
Post #10 of 11
(4036 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
Yea....It sounds like a connection problem. One other thing you can try is try is to take the neg cable off where it attaches to the block and clean that area. Maybe someone else has idea I've overlooked. There's a few thing it could be but without a voltmeter it's tough to check out.........
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 13, 2009, 9:07 PM
Post #11 of 11
(4034 views)
|
|
Re: Mercury tracer wont turn over
|
Sign In
|
|
Once you eliminate all connection issues, if you still have the problem, you may be looking at a bad starter. It will basically give you the same symptoms. You could try tapping on it while someone else tries to start it. If it responds to that, then blame the starter.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
