|
|
Nissan Quest 1996 won't start
|
|
|
| |
|
redinhawaii
User
Jun 19, 2012, 10:26 PM
Post #1 of 21
(7954 views)
|
Nissan Quest 1996 won't start
|
|
|
Wow, been thru a lot, changed the starter, changed the battery starer cable, seemed to fix it, but old problem is back, seems electrical, turn the key on, all lights go out, step on the brake, all lights go out, tried staring in neutral, wiggled the automatic shift handle, sometimes, all things are go, but then some days, lights are on, power is there turn the key, and all is dead... any ideas? thanks aloha red
|
|
| |
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jun 20, 2012, 5:00 AM
Post #2 of 21
(7905 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
How about the battery? Have you had it tested? Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Jun 20, 2012, 5:01 AM)
|
|
| |
|
redinhawaii
User
Jun 20, 2012, 10:36 AM
Post #3 of 21
(7883 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
That seems the culprit, getting a new one today thanks aloha red
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 20, 2012, 10:48 AM
Post #4 of 21
(7881 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Test it, charged and clean all cable connections. Replace if older or bad test results, T
|
|
| |
|
redinhawaii
User
Jun 20, 2012, 2:46 PM
Post #5 of 21
(7867 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Got a brand new battery, cables are new too, car doing the same thing, if I put it in neutral, wait for a while, and then it will not "short out" and the car will start, I had read something about the anti theft device shorting out and something about the horn shorting out the ignition switch / anti theft device in this model. any thoughts before I dive into the steering column? also something about switching the lights on and off three times resets the anti theft device as I do not have the controller....
|
|
| |
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jun 20, 2012, 6:04 PM
Post #6 of 21
(7851 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
If the alarm is going off and enabling the inhibiter relay, that will disable cranking of the engine. The horn and lights should be flashing when the alarm is going off though. You can disable the alarm by using the key to unlock the driver's door if it is going off. Turning the lights on and off doesn't do anything for the alarm system. You could be having a neutral safety switch issue, if you can start it in neutral, but not park. Your going to have to chase down the culprit in the starter circuit when it is acting up. You'll need a test light/volt meter and schematic to test the circuit. Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Jun 20, 2012, 6:05 PM)
|
|
| |
|
redinhawaii
User
Jun 20, 2012, 7:57 PM
Post #7 of 21
(7836 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Thanks for the reply I took the steering column cover off and the problem stopped, so it seems as it is / was something there, will test when I get the volt meter to test the circuit thanks aloha red
|
|
| |
|
redinhawaii
User
Jun 22, 2012, 11:24 AM
Post #8 of 21
(7808 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Nope that did not fix it, worked for a while, then it broke down again, seems to be electrical. seems something to do with the AntiTheft device. any thoughts?
|
|
| |
|
zmame
Veteran
/ Moderator
Jun 23, 2012, 11:34 AM
Post #9 of 21
(7784 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Try disconnecting the battery negative cable and stepping on the break pedal for 30 seconds and reconnect the negative terminal. Do you have a aftermarket anti-theft system/immobilizer?. If it starts every time after you reconnect the battery would give a strong indication to a module fault.. if it's doesn't it may still be a module or wiring also.
|
|
| |
|
zmame
Veteran
/ Moderator
Jun 23, 2012, 4:32 PM
Post #11 of 21
(7769 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Very bad idea to hardwire it.. especially if there is a electrical problem it could cause a fire.
|
|
| |
|
redinhawaii
User
Jun 23, 2012, 6:49 PM
Post #12 of 21
(7762 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Okay, but the clip part is no longer available, even from Nissan, maybe a junk yard? then it will be just what it is already an old electrical part... I could send a pic of the part... would that help.
|
|
| |
|
zmame
Veteran
/ Moderator
Jun 23, 2012, 7:31 PM
Post #13 of 21
(7758 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
sure post picture here.. there is a good possibility a aftermarket company makes the fuse.
|
|
| |
|
redinhawaii
User
Jun 24, 2012, 11:04 AM
Post #14 of 21
(7731 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Okay, it is the wiring "harness" that goes from the plus side of the battery to a fuse block. the harness cannot be purchased so I will have to make one up, it has two parallel wires that slide slide clip together, and end up at the same terminal. so it appears that it "splits the load" and sends it thru some "fuse cross link" (maybe I have the wrong term here) wire that will protect the fuse block / fuses from too much current overload, I just have to make one of these up, will get parts at Napa today... will keep you posted as to progress, thanks, thanks for the help. aloha red
|
|
| |
|
redinhawaii
User
Jun 24, 2012, 11:06 AM
Post #15 of 21
(7730 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
fusible link wire is the right term
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 24, 2012, 11:23 AM
Post #16 of 21
(7728 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Never say never but fusable link wire should be colored for the amps it should tolerate. Don't over do it as the idea of course is to blow before burning the thing up in flames, T
|
|
| |
|
redinhawaii
User
Jun 24, 2012, 11:45 AM
Post #17 of 21
(7722 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Yes, I understand, what is hard to find is the "slide" connectors, and why are there two wires that end up in the same terminal, to split the amps?
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 24, 2012, 12:54 PM
Post #18 of 21
(7716 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Are you just looking for a two wire male/female plug? Is yours any good by continuity? You could just splice in (do that right if you go there - soldered, shrink tubing over splice) and put in the section of wire that burned out. You said you had a NAPA available so things should be available for all that. Doesn't matter but what Island are you on? Spent a lot of time in HI, Oahu, Molokai and Lanai where at the time you would be SOL for anything, T
|
|
| |
|
telsal
New User
Nov 3, 2012, 8:45 PM
Post #20 of 21
(7328 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
i have a 94 nissan quest transmisson went out replaced with 95 transmission everything went back in place expect i have one problem cable from steering colum to transmission linkage do not match up what do i do
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Nov 4, 2012, 1:35 AM
Post #21 of 21
(7319 views)
|
Re: Nissan Quest 1996 won't start
|
|
|
Start your own thread with something about YOUR car and problems not another of another year on an old thread! Thread locked to prevent this crap...... T
|
|
| |
|